Elite
|
Capacity: |
2.91 GB 5400 rpm 10 ms |
ST-43401N/ND Elite 3 SCSI-2 Fast Wide
������� Write Protect option enable
� ���� Not used
� � �� Master off/Slave on - Spindle Sync
� � � ���������� Terminator Power Source (see below)�Ŀ
� � �J4A � � Terminators (SIP on single, �
�� ڴ ſ J01� � DIP on differential) �
�o oo o� J7 ��ij�Ŀ �����������Ŀ J4B �
�o oo o�o o o o o o-a-o-o�4o�o3������1�����1�����1 Power o o o o �
��������o o o o o o-b-o-o�2o o1�___________________ �12�G�G�5Ŀ o o o o �
�P�W�A�����������ͳ�^ͳͳ������( �����������������1)�͵ 0 0 0 0 ����������� �
8 4 2 1 � � � � � \�����������ij����/ \���������/ � � � � �
������� � � � � SCSI Cable Connector � � � � �
� � � � � � 68-pin � � � � �
SCSI ID ����� � � � � � � � � �
Motor ���������� � � � � Spinup Delay (10 secs * ID) �� � � � �
�Ground ����������� � � Motor Start option enable ���� � � �
�Key (no pin) ������� � � Parity enable ������ � �
�Spindle Sync (SSCLK-)� � Sweep Cycle enable �������� �
�Spindle Sync (SSCLK+)��� �
�� port a and b (horizontal) �
�
���������������������������������� �
� Terminator Power Source Options ������������������������������������������
����������������������������������������������������������������������Ŀ
� 2 & 4 � Initiator supplies power over the SCSI Bus for terminators. �
� Drive supplies no terminator power. �
� 1 & 2 � Drive supplies power for its own terminator resistor-paks �
� but not to SCSI Bus. This is the factory setting. �
� 1 & 3 �
� AND � Drive supplies power for external terminator at end of the �
� 2 & 4 daisy chain. Terminator resistor-paks must be removed. �
� This option is recommended only for last drive on daisy �
� chain. �
������������������������������������������������������������������������
T-RES descriptions: ST43401N 3 SIPs
ST43401ND 3 DIPs
ST-43401N/ND
Elite 3
UNFORMATTED CAPACITY _____________________3,554,871,600
FORMATTED CAPACITY (512 byte blk) ________2,912,484,864
AVERAGE SECTORS PER TRACK ________________99 (rounded down)
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________57,435
CYLINDERS ________________________________2,738/2,735 (user)
HEADS ____________________________________21
DISCS (5.25 in) __________________________11
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________THIN FILM
RECORDING METHOD _________________________ZBR RLL (1,7)
INTERNAL TRANSFER RATE (mbits/sec) _______35-52
INTERNAL TRANSFER RATE AVG (mbyte/sec) ___6.0
EXTERNAL TRANSFER RATE (mbyte/sec) _______20 Sync.
SPINDLE SPEED (RPM) ______________________5,400
AVERAGE LATENCY (mSEC) ___________________5.55
COMMAND OVERHEAD (mSEC) __________________<0.5
BUFFER ___________________________________512 Kbyte
Read Look-Ahead, Adaptive, Multi-Segmented
Cache
INTERFACE ________________________________SCSI-2 FAST Wide
BYTES PER TRACK __________________________49,000-72,800
SECTORS PER DRIVE ________________________5,696,655
BYTES PER CYLINDER _______________________1,058,400 to 1,587,600
TPI (TRACKS PER INCH) ____________________
BPI (BITS PER INCH) ______________________
AVERAGE ACCESS (ms) read/write ___________10/11
SINGLE TRACK SEEK (ms) read/write ________0.9/1.7
MAX FULL SEEK (ms) read/write ____________22.5/23.5
MTBF (power-on hours) Class A Room _______300,000
MTBF (power-on hours) Office _____________200,000
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: Single-ended/Differential
+12V START-UP (amps) _3.98/4.60
+12V TYPICAL (amps) __1.90/1.88
+5V START-UP (amps) __2.37/3.48
+5V TYPICAL (amps) ___1.96/2.77
TYPICAL ( watts seek/read)_32.60/36.41
IDLE (watts) ______________28.34/31.81
USER MANUAL PART NUMBER __________________83327630
OTHER ____________________________________
Synchronized Spindles, Sweep Cycle Capability
** Already low-level formatted at the factory with six spare sectors
per cylinder, one spare cylinders/unit, one system cylinder/unit, and
one diagnostic cylinder/unit.
Physical:
Height (inches/mm): 3.25/82.6
Width (inches/mm): 5.75/146.1
Depth (inches/mm): 8.0/203
Weight (lbs/kg): 7.8/3.6
Seagate reserves the right to change, without notice, product
offerings or specifications. (08/08/94)