Seagate ST4096N HARD DISK DRIVE REPAIR, Seagate ST4096N HARD DISK DRIVE SPECIFICATIONS,
Seagate ST4096N hard disk drive sales, Seagate ST4096N hard disk drive repair, Seagate ST4096N hard disk drive specifications, 
Seagate ST4096N Hard Disk Drive Repair, Seagate ST4096N Hard Disk Drive Specifications, Seagate ST4096N Seagate ST4096N
Specifications



seagate st4096n picture.
seagate st4096n picture.
seagate st4096n picture.

Seagate ST4096N Specifications
Model Capacity Size Height Bus Type Int.Type
ST4096N 83.9MB 5.25" FHT SCSI  

Legacy   :    ST4096
Legacy

Capacity: 
Speed: 
Average Read Time: 
 Cylinders: 
Heads: 
Sectors: 

80.2 MB
3600 rpm
28 ms
1024
9
17


ST-4096 ST412 MFM

                                                          �12�G�G�5Ŀ
                                                          � 0 0 0 0 �
 �Data Cable                    �Controller Cable   1     \�1�2�3�4�/
 ��������� ��                 �������������������� ���   ������������
              o o o o o o o o       1�����������Ŀ
              o o o o o o o o       ��������������
Drive Select->1 2 3 4 � � � �          �Resistor Termination Pack
                � � � � � � �
                � ��� � � � �
                �  �  � � � � Radial
                �  �  � � ��� Recovery Mode
                �  �  � ����� Write Fault
                �  �  ������� Not Connected
                �  ���������� Never Used (Drive Select 3 and 4)
                � If twisted cable, use Drive Select 2


                              ST - 4096

       UNFORMATTED CAPACITY (MB) ________________96.0
       FORMATTED CAPACITY (17 SECTORS) (MB) _____80.2
       ACTUATOR TYPE ____________________________VOICE COIL
       TRACKS ___________________________________9,216
       CYLINDERS ________________________________1,024
       HEADS ____________________________________9
       DISCS ____________________________________5
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________MFM
       TRANSFER RATE (mbits/sec) ________________5.0
       SPINDLE SPEED (RPM) ______________________3,600
       AVERAGE LATENCY (mSEC) ___________________8.3
       INTERFACE ________________________________ST412
       SECTORS PER DRIVE ________________________156,672
       TPI (TRACKS PER INCH) ____________________1,031
       BPI (BITS PER INCH) ______________________9,792
       AVERAGE ACCESS (ms) ______________________28
       SINGLE TRACK SEEK (ms) ___________________6
       MAX FULL SEEK (ms) _______________________55
       MTBF (power-on hours) ____________________40,000
       POWER REQUIREMENTS: +12V START-UP (amps) _4.0
                           +12V TYPICAL (amps) __1.3**
                           +5V TYPICAL (amps) ___1.3
                           TYPICAL (watts) ______23**
                           MAXIMUM (watts) ______55
       BUFFERED STEP PULSE RATE (micro sec) _____3-70
       WRITE PRECOMP (cyl) ______________________N/A (1025)
       REDUCED WRITE CURRENT (cyl) ______________N/A (1025)
       LANDING ZONE (cyl)________________________AUTO PARK
       IBM AT DRIVE TYPE ________________________35 or 12*

 * MAY REQUIRE A CONTROLLER WITH BIOS SUPPORT, OR FORMATTING
   AND PARTITIONING SOFTWARE.  ALSO, CHECK TO SEE IF YOUR CMOS SETUP
   HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE.

       **1.5 amps/25 watts FOR 2-BOARD ST-4096 ONLY

Seagate reserves the right to change, without notice, product 
offerings or specifications. (6/26/90)

All manufacturer's Names, Logos and trademarks are the properties of the respective manufacturer.


HOME Seagate drives All Hard Drives


Check our Media Store for all your Floppy Disk and Tape Supplies.


Contact us

Copyright © 1997 - 2011 Erv Fleckstein ( M. Farris & Associates ). All Rights Reserved.