Seagate ST15230N Hawk 4 HARD DISK DRIVE REPAIR, Seagate ST15230N Hawk 4 HARD DISK DRIVE SPECIFICATIONS,
Seagate ST15230N Hawk 4 hard disk drive sales, Seagate ST15230N Hawk 4 hard disk drive repair, Seagate ST15230N Hawk 4 hard disk drive specifications, 
Seagate ST15230N Hawk 4 Hard Disk Drive Repair, Seagate ST15230N Hawk 4 Hard Disk Drive Specifications, Seagate ST15230N Hawk 4 Seagate ST15230N
Specifications



seagate st15230n picture.
seagate st15230n picture.
seagate st15230n picture.

Seagate ST15230N Specifications
Model Capacity Size Height Bus Type Int.Type
ST15230N Hawk 4 4294MB 3.5" HHT SCSI2 Fast

Hawk 4   :    ST15230N
Hawk 4

Capacity: 
Speed: 
Average Read Time: 
 

4.29 GB
5400 rpm
11.4 ms




ST-15230N SCSI-2 Fast (Hawk 4)

  �����������ͻ
  � REAR VIEW �  (ST-15230N only)
  �����������ͼ

         50 pin I/O Cable Connection
         �
    J1�������������������������1� /���������\    TOP (HDA)
     ͵:::::::::::::::::::::::::�ͳ 0 0 0 0 ���
      �������������������������; ��5�G�G�12�    BOTTOM



  �����������ͻ
  � REAR VIEW �  (ST-15230NC only)
  �����������ͼ
                     80 pin I/O and DC Power Connection
                     �
    J1          /���ij���������������\      TOP (HDA)
     ����������/ �������������������� \����������
              (\�1������������������40/)    BOTTOM

     Notes on 80 pin I/O connector:
       pins  1 -  4 = +12v        41 - 44 = 12v GND
            34 - 36 = +5v         74 - 76 = 5v GND
                 37 = SYNC             77 = LEDC
                 38 = MTRON            78 = DLYDST
                 39 = SCSIA0           79 = SCSIA1
                 40 = SCSIA2           80 = SCSIA3

  Mating NC connector: AMP US p/n: 2-557103-1 straight-in, Male 80-pin
                                   2-557101-1 right angle to PCB

  �����������������ͻ
  � RIGHT SIDE VIEW �  (Both ST-15230N and ST-15230NC)
  �����������������ͼ


BACK   �͸       J2  12345678                    TOP (HDA)  FRONT
 OF    J1�����������������������P�W�A����������������������� OF
DRIVE  �;           ::::::::                    BOTTOM     DRIVE
                     ��������
   �Terminator Power ٳ������ Enable T-Res
  ڴTerminator Power �ٳ����� Start Delay (12 secs * ID)
  �         Reserved ��ٳ���� Motor Start
  �    Parity Enable �������� Write Protect
  �
  �
  � ��������������������������������Ŀ
  �Ĵ Termination Power-source Table �
    ����������������������������������������������Ŀ
    ������....�����....�����PWA edge�����          �
    �                                              �
    �  1 2     1 2      1 2                        �
    � �ķ       �ķ    ���ķ  A Drive Supplies Bus �
    � ���     ��    ����  B Drive Supplies Own �
    � ���     ���     � �   C Bus Supplies Drive �
    �   A       B        C                         �
    ����������Default�������������������������������


  ����������������ͻ
  � LEFT SIDE VIEW �  (ST-15230N only)
  ����������������ͼ             If these ID jumpers are used,
                                 then ID jumpers shown in front
                                 view ARE NOT USED.

  FRONT                TOP (HDA)                 J5 ���1� �͸BACK
   OF   ��������P�W�A������������������������������͵:::�͵J1 OF
  DRIVE                BOTTOM                       ���; �;DRIVE
                                                     ���
                                               ID 1 �ٳ�� ID 4
                                                    ID 2


  ������������ͻ
  � FRONT VIEW �  (Both ST-15230N and ST-15230NC)
  ������������ͼ
                                  ��ĴReserved. Shipped with cover installed.
                                  �  �Do not remove. Do not install jumpers
                      TOP (HDA)  ����͸     1
     ��P�W�A��������������������͵::::�::::::���
                 *    BOTTOM     ����;123456
                 �               J6    ������
            LED ��                     ������
                                  ID 4 ٳ���� Reserved
                                  ID 2 �ٳ��� Remote LED (pin-3 +5v)
                                  ID 1 ������ Reserved
                                               
      If these ID jumper are used, then ID jumpers shown in left side 
      view J5 or 80 pin I/O cable ARE NOT USED.


                            ST-15230N
                            Hawk 4

       UNFORMATTED CAPACITY (MB) ________________5170
       FORMATTED CAPACITY (xx SECTORS) (MB) _____4294
       AVERAGE SECTORS PER TRACK ________________110
       ACTUATOR TYPE ____________________________ROTARY VOICE COIL
       TRACKS ___________________________________75,848
       CYLINDERS ________________________________3,992 user
       HEADS ______PHYSICAL______________________19
       DISCS (3.5 in) ___________________________10
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________ZBR RLL (1,7)
       INTERNAL TRANSFER RATE (mbits/sec)________33.9 to 61.0
       EXTERNAL TRANSFER RATE (mbyte/sec) _______5.2 Async
       EXTERNAL TRANSFER RATE (mbyte/sec) _______10 Sync
       SPINDLE SPEED (RPM) ______________________5,411
       AVERAGE LATENCY (mSEC) ___________________5.54
       BUFFER ___________________________________512/2048 KByte
         Read Look-Ahead, Adaptive,
         Multi-Segmented Cache
       INTERFACE ________________________________SCSI-2 FAST
                                                 ASA II
       SECTORS PER DRIVE ________________________
       TPI (TRACKS PER INCH) ____________________4200
       AVERAGE ACCESS (ms) (read/write)__________10.4/11.4
         Includes controller overhead
       SINGLE TRACK SEEK (ms) ___________________2.1
       MAX FULL SEEK (ms) _______________________20.6
       MTBF (power-on hours) ____________________800,000
       SHOCK (G's):
                operating (Read/Write) __________10
                nonoperating ____________________60
       ACOUSTICS (typ/max dBA) __________________
       POWER REQUIREMENTS: +12V START-UP (amps) _2.4
                           +12V TYPICAL (amps) __0.54
                           +5V START-UP (amps) __0.61
                           +5V TYPICAL (amps) ___0.36
                           TYPICAL (watts) ______9
                           MAXIMUM (watts) ______11
       LANDING ZONE (cyl) _______________________AUTO PARK
       IBM AT DRIVE TYPE ________________________0 or NONE

       Physical:
                        Height (inches/mm):     1.62/41.1
                        Width  (inches/mm):     4.00/101.6
                        Depth  (inches/mm):     5.74/145.8
                        Weight    (lbs/kg):     2.1/0.93

Already low-level formatted at the factory with twelve spare sectors
per cylinder (all twelve spare sectors are on one track) and two
spare cylinders/unit.

ZBR = Zone Bit Recording = Variable sectors per track

Seagate reserves the right to change, without notice, product 
offerings or specifications. (06/24/95)

All manufacturer's Names, Logos and trademarks are the properties of the respective manufacturer.


HOME Seagate drives All Hard Drives


Check our Media Store for all your Floppy Disk and Tape Supplies.


Contact us

Copyright © 1997 - 2011 Erv Fleckstein ( M. Farris & Associates ). All Rights Reserved.