Seagate ST1401N HARD DISK DRIVE REPAIR, Seagate ST1401N HARD DISK DRIVE SPECIFICATIONS,
Seagate ST1401N hard disk drive sales, Seagate ST1401N hard disk drive repair, Seagate ST1401N hard disk drive specifications, 
Seagate ST1401N Hard Disk Drive Repair, Seagate ST1401N Hard Disk Drive Specifications, Seagate ST1401N Seagate ST1401N
Specifications



seagate st1401n picture.
seagate st1401n picture.
seagate st1401n picture.

Seagate ST1401N Specifications
Model Capacity Size Height Bus Type Int.Type
ST1401N 338MB 3.5" HHT SCSI2 SE

Legacy   :    ST1401N
Legacy

Capacity: 
Speed: 
Average Read Time: 
 

338.0 MB
4400 rpm
12 ms
ST-1401N SCSI-2

  �����������ͻ
  � REAR VIEW �
  �����������ͼ

         50 pin I/O Cable Connection
      �������������������������1�
    J4�:::::::::::::::::::::::::� /���������\
     ����P�W�A�������������������ͳ 0 0 0 0 ���
       �������1 �������1 �������1 ��5�G�G�12�
       �������� �������� ��������
        �Terminating Resistors�


  ����������������ͻ
  � LEFT SIDE VIEW �
  ����������������ͼ

                 12345678
                ��������͸
FRONT         J6�::::::::�                                      BACK
 OF   �����������1��������������P�W�A��������������������������  OF
DRIVE            ��������                                       DRIVE
     Factory Use ٳ������ Terminator Power (see below)�
     Motor Start �ٳ����� Terminator Power (see below)��Ŀ
     Start Delay ��ٳ���� Reserved                       �
   Write Protect �������� Parity   ��������������������������������Ŀ
                                   � Termination Power-source Table �
                                   �����������������������������������������Ŀ
                                   � 7 8    7 8   7 8                        �
                                   �  �ķ  �ķ   ���ķ  A Drive Supplies Own �
                                   � ��  ���  ����  B Drive Supplies Bus �
                                   � ���  ���   � �   C Bus Supplies Drive �
                                   �  A      B     C                         �
                                   �������������P�W�A�����������������������;

  �����������������ͻ
  � RIGHT SIDE VIEW �
  �����������������ͼ


           ���1�
BACK     J5�:::�                                                FRONT
 OF   �������������P�W�A���������������������������������������  OF
DRIVE       ���                                                 DRIVE
      ID 4 �ٳ�� ID 1   If these ID jumpers are used,
           ID 2         then ID jumpers shown in front
                        view ARE NOT USED.


  ������������ͻ
  � FRONT VIEW �
  ������������ͼ
                          If these ID jumper are used,
       �����͸            then ID jumpers shown in right side
     J7�:::::�            view ARE NOT USED.
     ���1������������P�W�A���������������������
        �����
   ID 4 ٳ��� Remote LED
   ID 2 �ٳ�� Spindle Synchronization (default jumper ON)
        ID 1

                              ST - 1401N

       UNFORMATTED CAPACITY (MB) ________________390
       FORMATTED CAPACITY (xx SECTORS) (MB) _____338*
       AVERAGE SECTORS PER TRACK ________________66
       ACTUATOR TYPE ____________________________VOICE COIL
       TRACKS ___________________________________9,900
       CYLINDERS ________________________________1,100 (user)
       HEADS ____________________________________9
       DISCS ____________________________________5
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________ZBR RLL (1,7)
       INTERNAL TRANSFER RATE (mbits/sec) _______20 to 25
       SPINDLE SPEED (RPM) ______________________4,412
       AVERAGE LATENCY (mSEC) ___________________6.8
       BUFFER ___________________________________64 Kbyte
         Read Look-Ahead, Adaptive,
         Multi-Segmented Cache
       INTERFACE ________________________________SCSI-2
       BYTES PER TRACK __________________________39,394 avg.
       SECTORS PER DRIVE ________________________653,400
       TPI (TRACKS PER INCH) ____________________1760
       BPI (BITS PER INCH) ______________________
       AVERAGE ACCESS (ms) ______________________12
       SINGLE TRACK SEEK (ms) ___________________2.5
       MAX FULL SEEK (ms) _______________________24
       MTBF (power-on hours) ____________________150,000
       POWER REQUIREMENTS: +12V START-UP (amps) _2.5
                           +12V TYPICAL (amps) __0.7
                           +5V TYPICAL (amps) ___0.7
                           TYPICAL (watts) ______9.1
                           MAXIMUM (watts) ______15
       BUFFERED STEP PULSE RATE (micro sec) _____
       WRITE PRECOMP (cyl) ______________________N/A
       REDUCED WRITE CURRENT (cyl) ______________N/A
       LANDING ZONE (cyl)________________________AUTO PARK
       IBM AT DRIVE TYPE ________________________0 or NONE

 * 512 bytes per sector, one spare sector per track,
   two spare cylinders per unit.

Already low-level formatted at the factory.
ZBR = Zone Bit Recording = Variable sectors per track

Seagate reserves the right to change, without notice, product
offerings or specifications. (9/24/97)

All manufacturer's Names, Logos and trademarks are the properties of the respective manufacturer.


HOME Seagate drives All Hard Drives


Check our Media Store for all your Floppy Disk and Tape Supplies.


Contact us

Copyright © 1997 - 2011 Erv Fleckstein ( M. Farris & Associates ). All Rights Reserved.