Seagate ST1096n HARD DISK DRIVE REPAIR, Seagate ST1096n HARD DISK DRIVE SPECIFICATIONS,
Seagate ST1096n hard disk drive sales, Seagate ST1096n hard disk drive repair, Seagate ST1096n hard disk drive specifications, 
Seagate ST1096n Hard Disk Drive Repair, Seagate ST1096n Hard Disk Drive Specifications, Seagate ST1096n Seagate ST1096N
Specifications



seagate st1096n picture.
seagate st1096n picture.
seagate st1096n picture.

Seagate ST1096N Specifications
Model Capacity Size Height Bus Type Int.Type
ST1096N 84MB 3.5" HHT SCSI1 SE

Legacy   :    ST1096N
Legacy

Capacity: 
Speed: 
Average Read Time: 
 

83.9 MB
3600 rpm
20 ms





Installation Guide | Product Manual

ST-1096N SCSI

                                                 /��Ŀ
                                                 � O �12
                                                 � O �G
                                                 � O �G
          o o o o o                              � O �5
          o o o o o                              \����
        ������������������������������������������������
          1 2 4 � P   ........................1
          ����� � �  �.........................�
            �   � � �������1�������1�������1
            �   � � ������������������������
            �   � �    � Resistor Termination Packs
            �   � �
            �   � �� Parity Check enable
            �   ���� Not Used
            �������� Drive ID's, ID 0 (none) for single drive system

                              ST - 1096N

       UNFORMATTED CAPACITY (MB) ________________N/A
       FORMATTED CAPACITY (26 SECTORS) (MB) _____83.9
       ACTUATOR TYPE ____________________________VOICE COIL
       TRACKS ___________________________________6,342
       CYLINDERS ________________________________906
       HEADS ____________________________________7
       DISCS ____________________________________4
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________RLL (2,7)
       TRANSFER RATE (mbits/sec) ________________7.5
       SPINDLE SPEED (RPM) ______________________3,600
       AVERAGE LATENCY (mSEC) ___________________8.3
       BUFFER ___________________________________2 Kbyte SeaCache
       INTERFACE ________________________________SCSI
       SECTORS PER DRIVE ________________________163,986
       TPI (TRACKS PER INCH) ____________________1,300
       BPI (BITS PER INCH) ______________________19,893
       AVERAGE ACCESS (ms) ______________________20
       SINGLE TRACK SEEK (ms) ___________________8
       MAX FULL SEEK (ms) _______________________44
       MTBF (power-on hours) ____________________150,000
       POWER REQUIREMENTS: +12V START-UP (amps) _2.0
                           +12V TYPICAL (amps) __0.5
                           +5V TYPICAL (amps) ___0.6
                           TYPICAL (watts) ______9
                           MAXIMUM (watts) ______33.75
       BUFFERED STEP PULSE RATE (micro sec) _____3-200
       WRITE PRECOMP (cyl) ______________________N/A (907)
       REDUCED WRITE CURRENT (cyl) ______________N/A (907)
       LANDING ZONE (cyl)________________________AUTO PARK
       IBM AT DRIVE TYPE ________________________0 or NONE

Seagate reserves the right to change, without notice, product 
offerings or specifications. (6/26/90)



HOME Seagate drives All Hard Drives


Check our Media Store for all your Floppy Disk and Tape Supplies.


Contact us

Copyright © 1997 - 2011 Erv Fleckstein ( M. Farris & Associates ). All Rights Reserved.